WB60TXRX - Wireless Reversing Camera Bridge Complete Set - Transmitter (TX) + Receiver (RX) - 60M Version

About the wireless reversing camera bridge - Sender/Receiver box set

• Wireless is a very easy way to get a reversing camera fitted to a trailer, or caravan.
• The receiver will plug in to any of our 4 pin monitors.
• The transmitter will plug in to any of our 4 pin reverse cameras.
• You will not experience any static on the picture, since the system only allows information from its paired/encrypted partner device.
• A 4 pin monitor will power the receiver.
• One power supply to the transmitter box is required - this will power your 4 pin camera too.
• Our 4 pin cables for reversing cameras can be used between the boxes and either monitor or reversing camera if required.

Works with all traditional CVBS reversing cameras (the type that is used 99% of the time). This isn't compatible with the new AHD (high definition) reversing cameras that we stock. We hope to have AHD sender / receiver boxes available for this new technology soon.

We don't recommend running two 60M transmitters close to each other, as the signal range will be decreased (although still impressive). This is similar to the advice about keeping your cordless phone base unit away from your wifi router. If you wish to use two reversing/rearview cameras on the one sender/receiver pair, then we recommend using our switching box - this changes channel when reverse is selected.

Please note that these boxes run best with PAL cameras, the majority of cameras sold in Europe. We do have a few models of camera that are NTSC, if you are concerned please contact us before ordering. If you are ordering a camera and WB60 set at the same time we will of course check compatibility before sending.