Parkingcameras.com

About the small number plate bolt reverse camera

This is the bolt version number plate reverse camera. Simply drill a small hole on the underside of your number plate ledge for the bolt of the camera to fit through. Then fasten to vehicle with the special split type nut provided. The result is a very small camera that is quite hard to even see! We have had this made by the same factory that makes our upgraded brake light cameras. Using their high quality PC4089 700TVL sensor and fully glass composite lens combination.

The camera has the 4 pin screw connector plug on its fly lead, to allow it to work with monitors that provide power to the camera down an all in one cable.

The camera is waterproof up to IP68, please note that the wiring connections must be inside due to an inline power regulator being placed on the cable.  This isn't usually an issue since the camera cable is designed to go straight in to the vehicle.

There is a trigger loop which can turn guidelines on/off.

Camera works on 12V but if you buy with a 12V/24V monitor, the monitor reduces the voltage down to 12V.  This is the norm, and most 24V systems actually only supply 12V to the camera.