Parkingcameras.com

Vauxhall Vivaro / Renault Trafic brake light reversing camera

When somebody wants a reversing camera for a van, the most popular option these days is a brake light reversing camera.  This is because of the following reasons:

• Easy to fit because it uses the original location and fixing method that has already been installed by the manufacturer
• No sealant required, as the new brake light reversing camera housing is fitted with a seal which is mechanically compressed against the original location of the old brake light
• The reversing camera is tidy and "factory look"

The reversing camera installed in this brake light camera has a ball design that has a very small adjustment up/down using a friction lock mechanism, it should be noted that this doesn't allow it to be angled to face upwards enough to view down the road as a driving camera.

The camera has been fitted with a 4 pin connector, which in the industry is widely considered to be the best connector.  If you are using a phono connector monitor/stereo then we can provide adaptors, please see the drop down menu to order.

The camera is waterproof up to IP68.

What vehicle does this brake light reversing camera fit?

Vauxhall Vivaro 2014-2019

Renault Trafic 2014-Present

How does the new camera replace the original brake light?

• Remove the power connector plug to the existing brake light two bolts to the rear of existing brake light
• Remove the two nuts secured to the bolts at the rear of the original brake light
• Take the old brake light housing off the door
• Remove the bulb from the old brake light
• Insert the old bulb to the new brake light reversing camera housing
• Position the new reversing camera brake light housing to the door and secure using the original nuts
• Attach the original brake light power connector plug in to the socket on the new brake light camera
• Attach the supplied extension lead between the 4 pin plug of the brake light camera and the 4 pin socket of the monitor wiring harness (this will go through the cable protector that goes between the van door and van body - the black plastic corrugated tube).

Image Sensor for Camera

This particular system uses the PC4089 1/3" Hi-Res CMOS image sensor (not to be confused with the older technology low res CMOS), this runs at 700TVL and gives a really crisp picture with a good colour replication. We use 4xglass composite lens instead of the cheaper 2xglass, 2xplastic lenses, which cloud/fade over time due to UV exposure. With our camera you can be assured of good performance and long term reliability.