Adaptors for reversing cameras

Adaptors for reversing cameras

We stock a number of reversing camera adaptors to convert one type of connector to another.  The most popular are the CAB99 used by Swift/Autotrail/Bessacarr, and the CAB00W and CAB001WY used to convert the Dometic/Waeco cable used in Baileys/Burstner motorhomes.  

Page of 2

PS/2 to 4 pin adaptors - Swift / Autotrail / Bessacarr / Sargent Electrical RV207 compatible adaptors | CAB99

CAB99M+CAB99M-Ch2

For a number of years we have stocked these adaptors to support customers who have a 6 pin mini din (PS/2) cable in their vehicle.

£24.00

VAT Included £4.00

Swift / Bessacarr / Autotrail reversing camera adaptor to change monitor from the RVM720/730 to Phono / RCA / Triggers / Power

Adaptor H

As part of our extensive range of motorhome reversing camera system support adaptors, this one allows people who have a RVM720/730 Mirror Monitor to change the monitor display to either a stereo headunit or a dash monitor with phono RCA inputs.

£24.00

VAT Included £4.00
Quantity

Waeco / Dometic / Baileys / Burstner Motorhome Pre-fitted Cable compatible adaptors 2010+ to Phono/RCA eg Stereo input | CAB00W-RCA+CAB00W4M

CAB00W-RCA+CAB00W4M

These cable adaptors will convert the 2010 onwards Waeco cable fitted on vehicles like Baileys to a single 4 pin socket/plug like we use on our single camera systems. Both front and rear adaptors are provided. These cables are not made by Waeco, just compatible.  We only sell these as pairs because we have found the inside of the cables to be wired in differently.

£18.00

VAT Included £3.00
Quantity

Waeco / Dometic / Baileys / Burstner Motorhome Pre-fitted Cable compatible adaptors 2010+ to Single 4 pin | CAB00W

CAB00W

These cable adaptors will convert the 2010 onwards Waeco cable fitted on vehicles like Baileys to a single 4 pin socket/plug like we use on our single camera systems. Both front and rear adaptors are provided. These cables are not made by Waeco, just compatible.  We only sell these as pairs because we have found the inside of the cables to be wired in differently, so you may not be able to just plug in one side and replace just one part, you would need to replace both monitor and camera.

£18.00

VAT Included £3.00
Quantity

Waeco/Dometic/Baileys/Burstner motorhomes Pre-fitted Cable Adaptors 2010 onwards to Twin 4 pin aviation | CAB001WY

CAB001WY

These cable adaptors will convert the 2010 onwards Waeco cable fitted on vehicles like Baileys to twin 4 pin sockets/plugs like we use on the twin camera systems. Both front and rear adaptors are provided.

£24.00

VAT Included £4.00
Quantity

4 Pin (Female) to RCA/Phono + Power Wires - reverse camera adaptor cable | CAB0020F-RCA

CAB0020F-RCA

This will convert our 4 pin reversing camera cable in to a conventional RCA/2.1mm Red/Black power connection if you wish to connect an RCA Phono camera on to 4 pin cabling.

£6.50

VAT Included £1.08
Quantity

4 Pin (Male) to RCA/Phono + Power Wires - reverse camera adaptor cable | CAB0020-RCA

CAB0020-RCA

This will convert our 4 pin reversing cameras to a conventional RCA/2.1mm DC connection if you wish to connect to an RCA monitor or stereo headunit

£6.50

VAT Included £1.08
Quantity

4 Pin (Male) to RCA/Phono reverse camera adaptor cable | CAB0020

CAB0020

This will convert our 4 pin cameras to a conventional RCA/2.1mm DC connection if you ever change to an RCA input monitor.

£4.20

VAT Included £0.70
Quantity

4 Pin (Male) to RCA/Phono/Audio reverse camera adaptor cable | CAB002

CAB002

This will convert our 4 pin cameras to a conventional RCA/2.1mm DC connection if you ever change to an RCA input monitor.

£4.40

VAT Included £0.73
Quantity

4 Pin (Female) to RCA/Phono reverse camera adaptor cable | CAB0020F

CAB0020F

Adaptor Cable designed to allow a phono/RCA based reversing camera on to a 4 pin aviation connector cabled system. This adaptor is approximately 100CM in length.

Female 4 Pin aviation connector to yellow video signal RCA Phono male plug, and 2.1/5.5mm DC plug for power.

£4.20

VAT Included £0.70
Quantity

4 Pin (Female) to RCA/Phono/Audio reverse camera adaptor cable | CAB002F

CAB002F

Adaptor Cable designed to allow a phono/RCA based reversing camera on to a 4 pin aviation connector cabled system. This adaptor is approximately 100CM in length.  

Female 4 Pin aviation connector to yellow video signal RCA Phono male plug, white audio signal RCA Phono male plug, and 2.1/5.5mm DC plug for power. 

£4.40

VAT Included £0.73
Quantity

ACC099 - Switching box allows two reversing cameras to use one channel/cable

ACC099-Trigger

We are often approached by customers who have a single cable installed in their motorhome, but who would like to fit either a second camera, or one of our twin lens cameras to provide both rear view/parking view.  One of the factories we use made this switching box for us.

£48.00

£36.00

25% Off VAT Included £6.00
Quantity

CAB041 - 4 Pin Male to bare wires - For soldering on to existing leads

CAB041

We very often get people who have an older system that has unusual connectors that wish to adapt their existing wiring to the industry standard - 4 pin aviation connector.  In the past, our customers used to purchase a 1M cable, which they would cut in half to connect each wire to their existing lead.  We decided to get our cable factory to make us a new 100cm length lead which has been pre-separated out to the individual wires.  

£3.60

VAT Included £0.60
Quantity

Adaptor for 5 pin version Fendt Tractor Vario Terminal

Adaptor N

This is the 5 pin version adaptor for the Fendt Vario - designed to be plugged in to the connection at the back of the arm rest converting it to a 4 pin "aviation" connector (as seen on almost all reversing cameras nowadays - including all of our selection).

These adaptors are 100cm in length. We have various extensions that will plug in to extend this adaptor, and a wide range of cameras that can be used.

£24.00

VAT Included £4.00
Quantity

Splits a feed from one camera in to two feeds for separate monitors / MDVR | CAB044

CAB044

We were frequently getting asked for a reversing camera cable splitter cable to allow one feed to go to 2x monitors, or 1x monitor and 1x MDVR.  This cable achieves this.

£6.60

VAT Included £1.10
Quantity

Female to Female 4 pin Gender changing cable (converts male 4 pin to female 4 pin) | CAB19

CAB19

Occasionally you meet a situation where you need to get two male 4 pin aviation reversing camera plugs to join up with each other. This cable allows you to do so.

£4.40

VAT Included £0.73
Quantity

Male to Male 4 pin Gender changing cable (converts female 4 pin to male 4 pin) | CAB037

CAB037

We occasionally get asked by customers for a cable to change the gender of a 4 pin aviation cable, this cable has male connectors both ends, meaning it can change a female connection in to a male connection.

£4.40

VAT Included £0.73
Quantity

F / F Female to Female Phono Coupler Adaptor to convert a Male/Plug to a Female/Socket | ACC090

ACC090

There are times when people find themselves with two male phono / RCA plugs that they need to join together. These female to female couplers help to overcome this and "couple" the two plugs together.

£0.75

VAT Included £0.13
Quantity

M / M Male to Male Phono Coupler Adaptor to convert a Female/Socket to a Male/Plug | ACC091

ACC091

There may be occasions where you need to connect two female RCA Phono connectors together.  This gender changer allows you to do so.

£0.75

VAT Included £0.13
Quantity

ACC093 - BNC Plug to RCA Phono (Female)

ACC093

ACC093 - BNC Plug to RCA Phono (Female)

£1.10

VAT Included £0.18
Quantity

CAB254P - 2.5mm 4 Pole Plug to Phono/RCA Adaptor (2.5mm used for some sat navs)

CAB254P

Some Sat Navs and Dashcams have a small socket that looks similar to a headphone jack.  This is designed to accept video (and sometimes audio).  This adaptor cable allows you to attach a video feed using the yellow RCA/Phono plug (audio too if your camera is equipped with a microphone).  If you are adapting one of our 4 pin cameras then you will need a 4 Pin to RCA/Phono adaptor and some of our phono couplers to allow everything to mate together.

Please note that sometimes you will see the same type of connector on cameras, most commonly cameras which attach with a bolt (as this connector allows the cable to fit through the small cable hole for the bolt).  This adaptor WILL NOT work on the camera - as this isn't designed to give power to a camera.  We do not have adaptors for the cameras since we have seen the power enter on different poles.

£3.30

VAT Included £0.55
Quantity

200cm Mini Fuse Tap "Piggyback fuse holder" to 2.1mm DC socket | CAB288

CAB288

We had these made up so that they would plug in to the 2.1mm DC sockets that are on most of our monitor wiring harnesses.  Fuse taps are a convenient way to tap into a power supply for your new camera system.

£6.60

VAT Included £1.10
Quantity

200cm Standard Fuse Tap "Piggyback fuse holder" to 2.1mm DC plug | CAB289

CAB289

We had these made up so that they would plug in to the 2.1mm DC sockets that are on most of our monitor wiring harnesses.  Fuse taps are a convenient way to tap into a power supply for your new camera system.

£6.60

VAT Included £1.10
Quantity

Lighter Plug Supply to 2.1mm/5.5mm DC power plug connector | CAB005

CAB005

A 12V lighter plug connection is still a popular option for people who either wish to test their reversing camera kit before hardwiring in, or for people who want the ultimate easy install.

£4.40

VAT Included £0.73
Quantity
Page of 2